31
Rev 20A
The below steps must be completed by a qualified electrician
Clearing Remote Controls:
•
To delete all paired remote controls,
•
Press and hold the learning button K4 for approximately 8 seconds. Once the indicator
light LRN turns off, all remote controls previously paired will be deleted.
Pairing Remote Controls:
•
While the motor housing cover and clear plastic PCB cover are removed,
•
Press the learning button K4 on the control board, until the indicator light LRN turns on,
then release the button.
•
While the light is on, press the first button on the remote control twice within 4 seconds,
the LRN will flash repeatedly and then turn off when remote control is paired.
Technical Support
For support or assistance with installing your gate motor, ring your local Richmond Wheel & Castor
Branch on 1300 474 246. For detailed technical support, ring our Engineering Department on 03 9551
2233.
Richmond Wheel & Castor Co declines all responsibility for any consequences resulting from improper use of
the product, or use which is different from that expected and specified in the present documentation.
Richmond Wheel & Castor Co declines all responsibility for any consequences resulting from failure to
observe Good Technical Practice when constructing closing structures (door, gates etc.), as well as from any
deformation which might occur during use.
Press and hold the learn
button (S1) until the Learn
LED flashes ON.
While the light is on,
press the first button on
the remote control twice.
The Learn LED will flash
repeatedly and then turn
OFF. when the remote is
paired.
