Ribind K400 230V, Инструкция по эксплуатации

Страница: 30 / 60

G G
B B
A - CONNEXIONS
Header for EXPANDER card
Header for secondary transformer
Power supply 230 Vac 50/60 Hz (on request
120V/60Hz) terminal block
Header for primary transformer
DO NOT TOUCH THE JUMPER !IF IT IS
REMOVED THE OPERATOR DOESN’T MOVE !
Connector to the manual release safety device
Connector to the Encoder (only for K PLUS)
Connector to the capacitor
Connector for limit switch connection
Limit switch contact stopping the motor opening
Contacts common unit
Limit switch contact stopping the motor closing
Connector for Motor connection
Blinker (max. 40W )
Radio Antenna
Contacts common unit
Photocells contact (NC)
Connector for the logic of the INVERTER card
(optional)
Contact of the stop button (NC)
Contact of the opening button (NO)
Contact of the closing button (NO)
Contact of a single impulse (NO)
24 Vac accessories power supply
Warning light - gate open 12Vdc
Buzzer - Wiring acoustic warning (12Vdc max
200 mA)
- PAY ATTENTION TO THE POLARITY -
Connector for radio receiver 24Vac
Heater Card Connector
Power Supply from the INVERTER card
(Optional - DO NOT ALTER THE SAFETY
DEVICE ! )
to adjust the speed of the deceleration, both in
opening and closing
to adjust the force of the operator through
the electronic clutch
J1
J2
J3
J4
J5
J6
J7
J8
J9
J10
J11
J12
J13
J14
J15
J16
J17
R2
R9
EXP.
SEC.TRANSF.
L1 - N
PRI.TRANSF.
SEC.LOCK
ENCODER
CAPACITOR
LSO
COM.
LSC
MOTOR
AERIAL
COM
PHOT.1 NC
INVERTER
STOP
OPEN
CLOSE
K BUTT.
A*A
SIGNAL
BUZZER
RADIO
HEATER
INVERTER
TRIMMER
LOW SPEED
TRIMMER
TORQUE