REXROTH Fv Series, Инструкция по эксплуатации

Страница: 94 / 222

1. Accurate motor parameters are required for vector control.
Motor parameters can be obtained by auto-tuning function,
please refer to parameters [S2.00] − [S2.10] for related set‐
tings. If auto-tuning is impossible and the accurate motor pa‐
rameters are known, first set parameters [S2.00] − [S2.04]
with values found on the motor nameplate. Then set param‐
eters [S2.05] − [S2.09].
2. In vector control mode, please set the parameters of rotation
speed controller to obtain good static and dynamic control.
See parameters [S1.00] and [S1.01] for related information.
3. In vector control mode, one frequency converter can only
drive one motor.
4. In V/F control mode, please refer to parameters in group S
for related settings.
b1.04
Digital set frequency Factory default 50.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
If “Frequency setting mode”[b1.00] = 1, value of [b1.04] is the set
frequency.
b1.05
Maximum frequency Factory default 50.00 Hz
Setting range 50.00 − 400.00 Hz Minimum unit 0.01 Hz
b1.06
Upper limit frequency Factory default 50.00 Hz
Setting range b1.07 − b1.05 Minimum unit 0.01 Hz
b1.07
Lower limit frequency Factory default 0.00 Hz
Setting range 0.00 Hz − b1.06 Minimum unit 0.01 Hz
● The “Upper limit frequency”[b1.06] and “Lower limit frequency” [b1.07]
represent the maximum and minimum allowed output frequency.
Fig.7-16: Maximum frequency_upper limit frequency_lower limit frequency
b1.08
Operating panel controlled direction Factory default 0
Setting range 0, 1 Minimum unit 1
Bosch Rexroth AG DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv
92/219
Parameter Settings