Fault messages
28
Pos : 8. 2 / 00005 Übersc hrift en/1. Übersc hrift en/1 Fe hler meldungen @ 2\ mod_1259056589728_9. doc @ 17580 @ 1
7 Fault messages
Pos : 8. 3 / 00010 Bedienungsanlei tungen/ 00140 Kapi tels ammlung Paddl e Blender/ 00150 Fehler meldung en/1501 PB M odul F ehl er mel dunge n @ 2\ mod_1263288791689_9. doc @ 18507 @
Error
message/problem
Cause
Remedy
Message:
!!! SIZE REDUCTION
FAILED
The sample cannot be
cut up.
Plates get stuck after 5
attempts.
Increase the speed.
If the blender is already running at maximum
speed, cut the sample into smaller pieces and
start the size reduction again.
If this does not remedy the fault, please ask
Customer Service.
Technical Fault
Motor does not turn.
Ask Customer Service.
Display blank
Blender is not switched
on.
Check if the blender is connected correctly
and switched on.
Fuse might be defective. Check the size and condition of the fuse on
the voltage selector switch at the back of the
blender.
If the size and condition of the fuse are alright
but the fault continues, ask Customer Service.
Faulty connection or
defective display
Ask Customer Service.
During size reduction
sample material
comes out of the bag
Maintenance problem or
incorrectly closed bag
Examine the condition of the black rubber
band that serves to hold the bag.
If necessary, clean with a sponge.
Check that the bag does not pucker when the
door is closed.
If this does not remedy the fault, please ask
Customer Service.
Pos : 9. 1 / 00010 Bedienungsanlei tungen/------- Seit enumbruc h ----------- @ 0\ mod_1222344373758_0. doc @ 2386 @
