Renault ALASKAN 2020, Руководство пользователя транспортного средства

Страница: 42 / 334

1. On the rear right outboard seating position:
1) Remove the head restraint of the rear right
outboard seat.
2) Route the top tether strap
➀
through the
right top tether guide (loop)
➁
and under the
centre shoulder belt
➂
.
3) Attach the top tether strap
➀
to the top tether
anchor (loop)
➃
at the rear centre seating po-
sition.
2. On the rear left outboard seating position:
1) Remove the head restraint of the rear left out-
board seat.
2) Route the top tether strap
➀
through the left
top tether guide (loop)
➄
.
3) Attach the top tether strap
➀
to the top
tether anchor (loop)
➃
at the rear centre seat-
ing position.
3. On the rear left and right seat simultaneous
use:
1) Follow steps 1 to 3 for each individual seat
fitment but do not tighten the straps until
both seats are anchored.
2) Then tighten each seat in turn taking care to
ensure equal tension.
Tighten the top tether according to the child re-
straint manufacturer's instructions.
CAUTION
After installing the required child restraint sys-
tem please ensure all portions of anchor straps
are securely tensioned.
When the top tether strap is properly tightened, the
top tether anchor (loop) may bend. This is normal
and will not damage the vehicle.
CHILD RESTRAINT INSTALLATION
USING ISOFIX
WARNING
•
Attach ISOFIX and i-Size child restraints only
at the specified locations. For the ISOFIX lower
anchor locations, see “ISOFIX lower anchor
point locations (Type A) (where fitted)” earlier
in this section. If a child restraint is not secured
properly, your child could be seriously injured
or killed in an accident.
•
Do not install child restraints that require the
use of a top tether strap to seating positions
that do not have a top tether anchor.
•
Do not secure a child restraint in the centre
rear seating position using the ISOFIX lower
anchors. The child restraint will not be secured
properly.
•
Inspect the lower anchors by inserting your
fingers into the lower anchor area and feeling
to make sure there are no obstructions over
the ISOFIX anchors, such as seat belt webbing
or seat cushion material. The child restraint
will not be secured properly if the ISOFIX an-
chors are obstructed.
•
Child restraint anchorages are designed to
withstand only those loads imposed by cor-
rectly fitted child restraints. Under no circum-
stance are they to be used for adult seat belts,
harnesses or for attaching other items or
equipment to the vehicle. Doing so could dam-
age the child restraint anchorages. The child
restraint will not be properly installed using
the damaged anchorage, and a child could be
seriously injured or killed in a collision.
JVR0422XZ
On the rear right outboard seating position
34
Safety — seats, seat belts and supplemental restraint system