Renault ALASKAN 2020, Руководство пользователя транспортного средства

Страница: 254 / 334

WARNING
To avoid serious personal injury while using
the emergency tyre puncture repair kit.
•
Securely tighten the compressor hose to
the tyre valve. Failure to do so can cause
the sealant to spray into the air and get into
your eyes or on your skin.
•
Do not stand directly beside the damaged
tyre while it is being inflated because of the
risk of rupture. If there are any cracks or
bumps,
turn the compressor off
immediately.
CAUTION
•
Do not operate the compressor for more
than 10 minutes. If the tyre pressure does
not increase to the specified pressure
within 10 minutes, the tyre may be seri-
ously damaged and the tyre cannot be re-
paired with this tyre repair kit. Contact an
approved dealer or qualified workshop.
9. When the tyre pressure is at the specified value,
close the pressure release valve and turn the air
compressor off. If the pressure cannot be inflated
to the specified value, the air compressor can be
turned off at the minimum of 180 kPa (1,8 bar, 26
psi) for tyre 205R16 250 kPa (2,5 bar, 36 psi). Re-
move the power plug from the power outlet and
quickly remove the hose from the tyre valve. At-
tach the protective cap and valve cap. Properly
stow the emergency tyre puncture repair kit in
the storage location.
WARNING
To avoid serious personal injury when stowing
the emergency tyre puncture repair kit, keep the
sealant bottle screwed into the compressor. Fail-
ure to do so can cause the sealant to spray into
the air and get into your eyes or on the skin.
10. Immediately drive the vehicle for 10 minutes or
3–10 km (2–6 miles) (if the road situation allows)
at a speed of
80 km/h (50 MPH) or less.
11. After driving 10 km (6 miles), or 10 minutes, screw
the air tube of the air compressor securely onto
the tyre valve. Check the tyre pressure with the
pressure gauge.
The temporary repair is completed if the tyre
pressure does not drop.
Make sure the pressure is adjusted to the pres-
sure that is specified on the tyre placard before
driving.
If the tyre pressure drops under 130 kPa (19 psi):
The tyre cannot be repaired with this tyre punc-
ture repair kit.
Contact an approved dealer or quali-
fied workshop.
If the tyre pressure is 130 kPa (19 psi) or more
but less than the specified pressure:
Turn the compressor switch to the ON (−) position
and inflate the tyre up to the specified pressure.
Then repeat the step from 8.
If the pressure drops again, the tyre cannot be re-
paired with this tyre puncture repair kit. Contact
an approved dealer or qualified workshop.
When the tyre pressure is the specified pressure:
The temporary repair is completed.
See an approved dealer or qualified workshop for
the repair/replacement as soon as possible.
After repairing tyre
See an approved dealer or qualified workshop for
tyre repair or replacement and for a new tyre seal-
ant bottle and hose, as soon as possible.
CAUTION
•
Before driving, ensure tyre is adjusted to rec-
ommended inflation pressure as indicated on
vehicle placard. Monitor tyre pressure until
sealed tyre is replaced.
•
Do not drive the vehicle at speeds faster than
50 MPH (80 km/h), and the damaged tyre must
be replaced as quickly as possible (within a
maximum driving distance of 200 km (120
miles)). You must not continue to drive if heavy
vibrations, unsteady steering behaviour or
noises should occur while driving.
•
Immediately after using Emergency Tyre Seal-
ant to repair a minor tyre puncture, take your
vehicle to an approved dealer or qualified
workshop to inspect, and repair or replace the
tyre. The Emergency Tyre Sealant cannot per-
manently seal a punctured tyre. Continuing
operation of the vehicle without a permanent
tyre repair can lead to a crash.
246
In case of emergency