Renault ALASKAN 2020, Руководство пользователя транспортного средства

Страница: 211 / 334

ACC position
The electrical accessory power activates at this po-
sition without the engine turned on.
ON position
The ignition system and the electrical accessory
power activate at this position without the engine
turned on.
OFF position
The engine is turned off with the steering wheel
unlocked.
REMOTE CONTROL KEY BATTERY
DISCHARGE
If the battery of the Remote Control Key is
discharged, or environmental conditions interfere
with the Remote Control Key operation, start the
engine according to the following procedure:
1. Automatic Transmission (AT) model:
Move the shift lever to the P (Park) position.
Manual Transmission (MT) model:
Move the shift lever to the N (Neutral) position.
2. Firmly depress the brake pedal.
3. Touch the ignition switch with the Remote Con-
trol Key as illustrated. (A chime will sound.)
4. Push the ignition switch while depressing the
brake pedal (AT model) or the clutch pedal (MT
model) within 10 seconds after the chime sounds.
The engine will start.
After step 3 is performed, when the ignition switch
is pushed without depressing the brake pedal (AT
model) or the clutch pedal (MT model), the ignition
switch position will change to “ACC”.
NOTE
•
When the ignition switch is pushed to the
“ACC” or “ON” position or the engine is started
by the above procedures, the Key Battery low
warning appears on the vehicle information
display even if the Remote Control Key is in-
side the vehicle. This is not a malfunction. To
turn off the warning, touch the ignition switch
with the Remote Control Key again.
•
If the Key Battery low warning appears on the
vehicle information display, replace the bat-
tery as soon as possible. (See “Remote Control
Key battery replacement” in the “8. Mainte-
nance and do-it-yourself” section.)
1. Apply the parking brake.
2. Depress the footbrake pedal.
3. Automatic Transmission (AT) model:
Move the shift lever to the P (Park) or the N (Neu-
tral) position.
The starter is designed to operate only when
the shift lever is in the proper position.
Manual Transmission (MT) model:
Move the shift lever to the N (Neutral) position
and depress the clutch pedal to the floor while
starting the engine.
4. Crank the engine with your foot off the accelera-
tor pedal by placing the ignition switch in the
<START> position.
Place the ignition switch in the <ON> position and
wait until the glow plug indicator light
turns off.
5. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
6. Allow the engine to idle for at least 30 seconds
after starting the engine to warm-up. Drive at
moderate speeds for a short distance first, espe-
cially in cold weather.
CAUTION
Do not leave the vehicle unattended while the en-
gine is warming up.
SSD0944Z
STARTING ENGINE (models
without Remote Control Key
system)
Starting and driving
203