Renault ALASKAN 2017, Руководство водителя, Страница: 39 / 340

CHILD RESTRAINT ANCHORAGE
(where fitted)
Your vehicle is designed to accommodate a child
restraint system on the rear seat. When installing a
child restraint system, carefully read and follow the
instructions in this manual and those supplied with
the child restraint system.
WARNING
Child restraint anchorages are designed to with-
stand only those loads imposed by correctly fit-
ted child restraints. Under no circumstances are
they to be used for adult seat belts, harnesses or
for attaching other items or equipment to the
vehicle. Doing so could damage the child re-
straint anchorages. The child restraint will not be
properly installed using the damaged anchorage,
and a child could be seriously injured or killed in
a collision.
ISOFIX Top Tether anchor location
The anchor point is a strap loop located on the top
of the second row centre seatback
➁
. There are
two similar straps at the back of the 2nd row outer
seats that are intended only as guide loops
➀
.
If the child restraint manufacturer recommends that
the top tether strap be attached, attach and tighten
the top tether strap to the top tether anchor (loop).
Refer to the child restraint instructions and the fol-
lowing steps.
1. On the rear right outboard seating position:
1) Remove the head restraint of the rear right
outboard seat.
2) Route the top tether strap
➀
through the
right top tether guide (loop)
➁
and under the
centre shoulder belt
➂
.
3) Attach the top tether strap
➀
to the top tether
anchor (loop)
➃
at the rear centre seating
position.
2. On the rear left outboard seating position:
1) Remove the head restraint of the rear left out-
board seat.
2) Route the top tether strap
➀
through the left
top tether guide (loop)
➄
.
3) Attach the top tether strap
➀
to the top tether
anchor (loop)
➃
at the rear centre seating
position.
3. On the rear left and right seat simultaneous
use:
1) Follow steps 1 to 3 for each individual seat
fitment but do not tighten the straps until both
seats are anchored.
2) Then tighten each seat in turn taking care to
ensure equal tension.
Tighten the top tether according to the child re-
straint manufacturer’s instructions.
CAUTION
After installing the required child restraint sys-
tem please ensure all portions of anchor straps
are securely tensioned.
When the top tether strap is properly tightened, the
top tether anchor (loop) may bend. This is normal
and will not damage the vehicle.
NIC2805
JVR0422XZ
On the rear right outboard seating position
Safety — seats, seat belts and supplemental restraint system
1-21