Reinke Ontrac, Инструкция по установке и обслуживанию

Страница: 87 / 207

Begin Installation:
1. Verify analog 2 jumper configuration.
2. Remove enclosure from the post unit or lid from the Ontrac tower box.
3. Disconnect the battery cable from the RTU Board.
4. Unplug everything from the RTU board (Note the location of everything).
5. Remove the RTU Board from the Ontrac unit.
6. Install RTU board from the pressure transducer assembly.
7. Reconnect all plugs to the RTU board.
8. Install transducer to the water pipe. (If necessary tee it into the water pipe using a 1/8” NPT fitting)
9. Bring the transducer wire harness with strain relief into the Ontrac unit.
10. To wire the Pressure Transducer into the RTU board;
A. Wire into Analog Input 2.
a. Connect the black wire from transducer to the black terminal.
b. Connect the green wire from transducer to the white terminal.
c. Connect the red wire from transducer to the red terminal.
d. White wire will not be used.
11. Hardware install is complete.
12. BEFORE LEAVING THE FIELD, COMPLETE VERIFICATION PROCEDURE BELOW
VERIFICATION:
1. Use internet access
/field_test and radio number to verify communication http://admin.ontracbyreinke.com
and input status.
2. Make sure Orbcomm Pressure shows up on the test site.
3. Compare the raw number status to pressure (keep in mind the approximate scale)
PSI=Raw No. x .39101 - 40
4. Run the pivot with and without water pressure to verify the transducer is working
correctly.
5. Call Reintech at 1-888-872-2360 to complete setup.
5. If questions or concerns arise contact technical support.
6. Verification is complete.
13
Options: Setra Pressure Transducer Retro Fit (350734R)
Ontrac Installation Manual
204
102
306
40 PSI
0 PSI
80 PSI
409
120 PSI
511
613
160 PSI
200 PSI
Approximate scale
Raw No. Pressure