Reinke Ontrac, Инструкция по установке и обслуживанию

Страница: 129 / 207

Ontrac Installation Manual
26
Cell Option: GPS Navigator Cable (350774)
350974
- Ontrac Cell Navigator GPS Cable: Data Cable Assy-Ontrac Navigator GPS (P/N 110547), WDHD
5522 ½” NPT .19-.25 (P/N 112467), Locknut-1/2” Elect Conn (P/N 113136)
Verify that all parts match accordingly.
!
350974 - (Ontrac Cell-GPS NAVIGATOR CABLE) -
This option provides the serial communications
cable to connect an Ontrac Cell-Base Unit (350785) with a Reinke Navigator EOS GPS option. This allows
remote monitoring of system position using standard Reinke Navigator GPS equipment.
Installation:
1. Verify that all parts match accordingly.
2. This option can be installed at either the EOS or Pivot Center Resolver Board location. The wiring is
similar for each location.
2. Disconnect the battery, solar, and power supply from the G2 Board.
3.
Pivot Center mounting location:
a. Install a strain relief in the system main control panel. Choose any available ½” knock out.
4. End of System mounting Location:
a. Drill a 7/8” hole and install a strain relief in the Ontrac Cell-Base Unit. Install the Strain
Reliefs and Data Cable between the Ontrac Cell-Base Unit and the Navigator GPS Resolver
Box. The 8 position plug goes to the Ontrac box and the flying red/black leads to the
Resolver Box.
5. Connect the 8 position plug to the Modem Socket B serial port (J26).
6. Connect the Data Cable red/black wires to the Resolver Board Serial and Ground terminals as shown on
the next page.
7. Verify the Resolver Board serial out is set for ONTRAC.
8. Connect the battery, solar and power supply to the G2 board.
9. When the G2 board is powered press the Enter button twice to enter the main menu.
10. Press Back to select GPS and press Enter.
11. Press Enter for GPS mode.
12. Press Back to select External and press Enter.
13. Press Escape until the home screen is displayed.
14. Installation is complete.
15. Install all other options before verifying.
Verification
1. Start the system to verify the position on the Ontrac LCD home screen updates accurately. It will
update every 20 seconds. Pressing Escape will refresh the position displayed.
2. Use the ontracbyreinke.com website (user interface) or http://admin.ontracbyreinke.com/field_test,
(requires radio number), to verify proper communication and GPS position reporting.
Note: The field test website is only required if raw data is needed to verify
correct unit operation or ontracbyreinke.com has not been previously setup.
3. If you have questions or concerns contact technical support.
4. Verification complete.
5. Verify all installed options before leaving the field.
Note: This option will not work with CDW Boards using
VRI Technology.