Reinke Ontrac, Инструкция по установке и обслуживанию

Страница: 35 / 207

Ontrac Tower Mount With Stop & GPS-Iridium (350784GPS)
Ontrac Installation Manual
108
Quick Reference Guide
Ver. 2G
Use S3 to toggle
SETBASE0,1,2,3
GPS CDW SETUP
Setup Program Function
,
Board Type
Sets the board type to pivot center for main control panel mounted boards.
Piv Cen-
Sets the board type to End of System for Tower Box mounted boards.
End Sys-
Com Type
The default Cold Wire operating mode used anytime two Cold Wire Boards are used.
Ver 2-
Used to allow the Cold Wire board to replace either the Hot Wire EOS Board or the Hot Wire Ver 1-
Line Receiver. When using Ver 1 make sure jumper J6 is in Hot Wire position.
Set Base
Forces the base set routine to start when exiting the setup program.
Yes-
Default
No-
Test Sig
Produces a square wave test signal for troubleshooting the cold wire communication link.
SQ Wave-
Produces test position signals of 0°,90°,180°,270°. The GPS Receiver must be disconnected 0-270-
for this mode.
Default No-
Serial Out
Default, formats the serial data for use by Ontrac.
Ontrac-
for future use.
Analog-
for future use.
Tim/Pos-
for future use.
Lat/Lon-
Use Waas
Default, uses the waas signal for improved accuracy. Yes-
Turns waas mode off, used outside of the USA where waas is not available. No-
Antenna
used with Garmin 17 and 17x Receivers.
Garmin-
used with Hemisphere Receiver.
Hemi-
Reset GPS
sends signal to reset the GPS receiver. Yes-
No-
Default
Position
Displays the GPS position data. For reference only, no programmable settings.
Num Reset
Displays the number of GPS resets sent. For reference only, no programmable settings.
End Setup
This will save all programming changes and exit the setup program. If this step is not completed all
changes will be lost.