Reinke Ontrac, Инструкция по установке и обслуживанию

Страница: 10 / 207

Iridium Radio Retro Fit (350781)
Ontrac Installation Manual
83
Make certain that mounting plate is behind the PEM NUTS as shown.
Installation
Step 1:
Install the new RTU chip from the kit. Make sure to match the notch on the chip with the
notch on the chip socket.
Step 3: Connect the wire harness w/6 position connector to the RTU Board as shown below Left. Connect the
red wire from the radio to the red terminal on input 4.
Step 2: Mount radio in one of the three following ways depending upon what type of Ontrac Unit is installed.
New Style Tower Box: 4- #6 x 1/4” Screws (P/N 3040)
Post Box: 4- #6 x ½” Screws (P/N 3009), 4- nylon washers (P/N 1531) and 4- star lock nuts (P/N 1097)
Old Style Tower Box: 2- #6 x ½”Screws (P/N 3009), 2- nylon washers (P/N 1531 and 2- star lock nuts
(On the old style Tower Mount the screws will not go through the mounting plate)
Use existing holes from the radio that was removed earlier.
Notch Location
POST MOUNT
ENLARGED TO
SHOW DETAIL
TOWER MOUNT
NEW STYLE
TOWER MOUNT
OLD STYLE
!