C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
9
RED 3-AXIS SYSTEM OPERATION GUIDE
CHAPTER 1:
3-AXIS SYSTEM OVERVIEW
INTRODUCTION
The RED
®
3-Axis Lens Control System is a versatile and highly accurate wireless lens control system. Use the RED
Wireless Motor Driver (W.M.D.), RED Tactical Hand Controller (T.H.C.), RED Lens Control Motor, and related RED
accessories to configure a low- profile lens control system for your camera rig. This guide provides setup and
operation instructions for the RED Lens Control Motor, W.M.D., T.H.C., and related accessories.
The T.H.C. is also compatible with the R.C.P.™ Bridge for wireless control of supported Canon
®
and Nikon
®
motorized lenses. For more information, see the camera
, available at
The T.H.C. cannot pair directly to the WEAPON
®
, SCARLET-W, and RED RAVEN™ cameras. To use the T.H.C. with
WEAPON, SCARLET-W, or RED RAVEN, the T.H.C. needs to be connected to the W.M.D. (either wired or wirelessly).
For more information about WEAPON/SCARLET-W, see the camera
at
.
WARNING:
ALWAYS use the RED motor cable with the appropriate internal identification resistor when using RED
Lens Control Motors with third-party motor drivers. Any damage caused to motors or motor drivers resulting from the
use of third-party cables is not covered under warranty.
NOTE:
The camera does not require a minimum firmware version for operation with the W.M.D., T.H.C., RED Lens
Control Motor, and other components of the RED 3-Axis Lens Control System.
Figure: 3-Axis Lens Control System
