SET A LENS LOCK
The W.M.D. can support wireless communication with up to two (2) T.H.C. units at any given time. Use the lens
function lock feature on the T.H.C. to prevent conflicting commands from two (2) T.H.C. units.
1. Press and hold the
Limit
button for a lens function for three (3) seconds. DO NOT make adjustments to the
knob/slider during this time.
Figure: Hold Limit Button for 3 sec
2. Release the
Limit
button when the corresponding LED changes from long blinks to quick blinks.
The lens function is now locked for that T.H.C. unit. The lens function LED quickly flashes green to signal an active
lens lock.
REMOVE A LENS LOCK
1. Press and hold the
Limit
button for a lens function for three (3) seconds.
2. Release the
Limit
button once the corresponding LED becomes solid.
The lens function is now unlocked.
RECORD START/STOP WITH THE T.H.C.
The Battery/Tally LED, near the top of the T.H.C., flashes when the camera is recording.
1. Press and release the
Run
button to start recording.
2. Press and release the
Run
button again to stop recording.
NOTE:
The Battery/Tally LED serves a dual purpose on the T.H.C. Flashing indicates that the camera is rolling,
color indicates battery charge level.
NOTE:
Note: The W.M.D. must be configured for the Start/Stop operation. For more information, go to
.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
4 5
RED 3-AXIS SYSTEM OPERATION GUIDE
