CONFIGURE THE 3-AXIS SYSTEM
1. Pair the T.H.C.
A. Ensure that the W.M.D. is receiving power.
B. Connect the T.H.C. to the W.M.D. using a RED CAN Command Cable.
C. Toggle the T.H.C. power switch to
Cable
mode.
The T.H.C. automatically syncs wireless information when a cabled connection is established with the W.M.D.
D. Remove the RED CAN Command Cable.
E. Install a RED Li Battery 7.2V.
F. Toggle the T.H.C. power switch to
Battery
mode.
The T.H.C. searches for the wireless connection. The wireless LED stops flashing and remains solid blue when
connected.
NOTE:
For more information, go to
2. Set motor type.
A. Go to
W.M.D. main menu
>
Focus/Iris/Zoom
>
Model
.
B. Select your motor type.
NOTE:
For more information, go to
"Select Motor Type/Model" on page 27
.
3. Configure wireless settings.
A. Select
Wireless
in the W.M.D. main menu.
If you are operating the T.H.C. in close proximity (up to 25 feet), select
Low
.
If you are operating the T.H.C. from greater distances (over 25 feet), select
High
.
If operating multiple systems in the same vicinity, select a unique wireless channel.
NOTE:
For more information, go to
"Configure Wireless Settings" on page 28
.
4. Initialize motors.
A. Press and hold the
Initialize
button on the T.H.C., or the
B
button on the W.M.D. for two (2) seconds.
NOTE:
For more information, go to
"Initialize the System" on the next page
.
The RED 3-Axis Lens Control System is now successfully setup and ready for wireless operation. The remainder of
this section offers further guidance on initialization.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
1 6
RED 3-AXIS SYSTEM OPERATION GUIDE
