2. Toggle the T.H.C. power switch to
Cable
mode.
The T.H.C. is connected and ready for wired operation.
Figure: T.H.C. Wired Connection
PAIR THE T.H.C.
Connect and pair the T.H.C. with your W.M.D. to operate in wireless mode. Once paired, the T.H.C. stores wireless
information for that W.M.D. and automatically reconnects when in range.
1. Ensure the W.M.D. is receiving power.
2. Connect the T.H.C. to the W.M.D. using a RED CAN Command Cable.
3. Toggle the T.H.C. power switch to
Cable
mode.
The T.H.C. automatically syncs wireless information when a cabled connection is established with the W.M.D.
4. Remove the RED CAN Command Cable.
5. Install a RED Li Battery 7.2V.
6. Toggle the T.H.C. power switch to
Battery
mode.
The T.H.C. searches for the wireless connection. The wireless LED stops flashing and remains solid blue when
connected.
NOTE:
The RED CAN Command Cable also provides power to the T.H.C. up to approximately 500 ft. When using a
cable longer than 500 ft, insert a battery and toggle the T.H.C. power switch to
Battery
to provide sufficient power.
The CAN cable continues to support wired communication over a much longer distance.
NOTE:
For more information, go to
"Configure Wireless Settings" on page 28
.
CHANGE THE WIRELESS CHANNEL
The best way to update the wireless channel on the T.H.C. is to repeat the pairing process by establishing a wired
connection to the W.M.D. If it is inconvenient to establish a wired connection, you can manually set the wireless
channel on the T.H.C.
1. Power off the T.H.C. by toggling the T.H.C. power switch to
Cable
mode.
2. Press and hold the
Focus Limit
button, and toggle the T.H.C. power switch to
Battery
mode.
The focus and iris LEDs alternate turning on and off.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
4 2
RED 3-AXIS SYSTEM OPERATION GUIDE
