red lion CUB 1, Руководство пользователя

Страница: 105 / 154

21
6.6 MODULE 6 - S
ETPOINT
(A
LARM
) P
ARAMETERS
(
708,"
)
PARAMETER MENU
Module 6 is the programming for the setpoint (alarms) output parameters. To have setpoint outputs, a setpoint Plug-in card needs to
be installed into the PAX (see Ordering Information). Depending on the card installed, there will be two or four setpoint outputs
available. This section replaces the bulletin that comes with the setpoint plug-in card. Please discard the separate literature when using
the Plug-in card with the Digital PAX. For maximum input frequency, unused Setpoints should be configured for
+55
action.
The setpoint assignment and the setpoint action determine certain setpoint feature availability. The chart below illustrates this.
SETPOINT PARAMETER AVAILABILITY
!
"
*+
%&%1#
SETPOINT SELECT
Select a setpoint (alarm output) to open the remaining module menu. (The
“ 9 ” in the following parameters will reflect the chosen setpoint number.) After
the chosen setpoint is programmed, the display will default to %&%1# *+ . Select
the next setpoint to be programmed and continue the sequence for each setpoint.
Pressing
PAR at %&%1# *+ will exit Module 6.
!
"
*+!
#='8-
SETPOINT ANNUNCIATORS*
+55 disables the display of the setpoint annunciator. Normal ( *+! ) displays
the corresponding setpoint annunciator of an “on” alarm output. Reverse ( !1: )
displays the corresponding setpoint annunciator of an “off” alarm output.
5#.%" flashes the display and the corresponding setpoint annunciator of an
“on” alarm output.
*+ %&83 %&8>
%&8? %&8@
+55 *+! !1: 5#.%"
!
"
*+!
+9'8-
SETPOINT OUTPUT LOGIC *
Normal ( *+! ) turns the output “on” when activated and “off” when
deactivated. Reverse ( !1: ) turns the output “off” when activated and “on” when
deactivated.
!
"
+55
%9&8-
SETPOINT POWER UP STATE *
%.:1 will restore the output to the same state it was at before the meter was
powered down.
+*
will activate the output at power up.
+55
will deactivate the
output at power up.
*
Factory Setting can be used without affecting basic start-up.
*+! !1:
%.:1 +55 +*
rSAE-n
rSAS-n
rSd-n
AUtO-n
tOUt-n
tON-n
tOFF-n
HyS-n
Stb-n
tyP-n
trC-n
Yes No Yes No No No Reset When SPn+1 Deactivates
Yes No Yes No No No Reset When SPn+1 Activates
Yes No Yes No No No Reset With Display Reset
Yes No Yes No No No Counter Auto Reset
No No Yes No No Yes Setpoint Time Out
No No No Yes Yes Yes Setpoint On Delay
No No No No Yes No Setpoint Off Delay
No No No No Yes No Setpoint Hysteresis
No Yes No Yes Yes Yes Standby Operation
No Yes No Yes Yes Yes Boundary Type
Yes Yes Yes Yes Yes Yes Setpoint Tracking
Yes Yes Yes Yes Yes Yes Setpoint Value
Yes Yes Yes Yes Yes Yes Power Up State
Yes Yes Yes Yes Yes Yes Output Logic
Yes Yes Yes Yes Yes Yes Annunciators
LATCH
%:"!'
BOUNDARY
*+4)2
TIMED OUT
"+4"
LATCH
%:"!'
BOUNDARY
*+4)2
TIMED OUT
"+4"
COUNTER RATE
DESCRIPTION
SP-n
SUP-n
OUt-n
LIt-n
PARAMETER