Raymarine gS Series, Инструкция по установке и эксплуатации, Страница: 146 / 208

Engine identification
Engine data can be displayed on your MFD using the Data
application, which provides some preset Engine pages for
displaying some of the most common types of engine data.
Important: Before you can display Engine data on your MFD,
you must:
• Ensure that your MFD is running LightHouse software
version 8 or later.
• Refer to the important “Engine setup with an ECI
interface” and “Using the engine identification wizard”
information.
• Make the data connections, according to the instructions
provided in the 87202 ECI Installation instructions .
• Ensure all data buses are powered up (including engine
data CAN buses, gateways, and also the SeaTalk ng bus).
• Start the engine. It is important that only one engine is
running at a time, to ensure that the system can isolate the
correct engine data message.
• Run the Engine identification wizard to ensure that your
engines are displayed in the correct order in the Data
application.
Using the engine identification wizard
If your engine data appears in the wrong order on the engine
data pages you can correct this by running the engine
identification wizard.
From the Homescreen:
1. Select Set-up > System Settings > External Devices >
Engines Set-up .
2. If required change the number of engines your vessel has
by selecting Num. of Engines: and entering the correct
number of engines.
You can select up to 5 engines.
3. Select Identify engines .
Important: It is important that only one engine is running at a
time, to ensure that the system can isolate the correct engine
data message.
4. Follow the onscreen prompts to complete the engine
identification wizard.
The engines that will be included in the identification wizard
are determined by the Number of engines set during step
2 above.
i.
Switch Off ALL vessel engines and select Next .
The wizard will run through all engines (max of 5 as
defined in step 2 above) from port to starboard in
sequence.
ii. Turn On the port engine and select OK .
The wizard will now listen for data and assign the engine
instance as the port engine.
iii. Turn On the center port engine and select OK .
The wizard will now listen for data and assign the engine
instance as the center port engine.
iv. Turn On the center engine and select OK .
The wizard will now listen for data and assign the engine
instance as the center engine.
v. Turn On the center starboard engine and select OK .
The wizard will now listen for data and assign the engine
instance as the center starboard engine.
vi. Turn On the starboard engine and select OK .
The wizard will now listen for data and assign the engine
instance as the starboard engine.
5. Select OK on the Identify Engines confirmation dialog.
The engines will now appear in the correct location on the
engine data page.
Setting maximum engine RPM
You can set the maximum RPM range to display on the RPM
data item.
From the data application:
1. Select Menu .
2. Select Max RPM Range .
A list of available RPM settings is displayed.
3. Select the required RPM range.
A tick will be placed next to the selected RPM range in the
menu and the RPM range on the engine datapage will be
changed to your new setting.
Examples
Auto* 10,000 RPM
Note: *The maximum RPM when in auto mode is set by the
engine.
Color theme
The color theme in the Data application can be switched
between light and dark.
Dark
theme (default)
Light theme
Changing the color theme
You can change the color theme by following the steps below.
From the Data application:
232
gS Series