Raymarine gS Series, Инструкция по установке и эксплуатации, Страница: 100 / 208

Depth data source
Where multiple sources of depth data exist on a system and
the depth Data Source is set to Auto then the system will
automatically select the optimum source for depth data.
The system will set the data source for depth according to the
priority table below:
1 st CP450C SeaTalk hs
2 nd CP300 SeaTalk hs
3 rd
DSM300 SeaTalk hs
4 th DSM30 SeaTalk hs
5 th Traditional sonar
variant multifunction
displays SeaTalk hs / internal
6 th DownVision TM variant
multifunction display
SeaTalk hs / internal
7 th
CP100 SeaTalk hs
8 th Instrument /
multifunction display SeaTalk ng
9 th Instrument SeaTalk
10 th Instrument /
multifunction display NMEA 0183
If multiple sonar modules of the same type are present on a
SeaTalk
hs network then the unit with the highest serial number
will be selected as the preferred data source. For SeaTalk ng and
NMEA 0183 networks the unit with the highest CAN address
is selected.
If the preferred depth data source becomes unavailable then the
system will automatically select the next highest priority data
source.
Refer to the Data Source menu section for details on selecting
preferred data sources.
Important: Depth offset must be set for all installed
transducers to ensure consistent and accurate data shown.
Refer to the
Depth Offset section for details.
17.6 Custom channels
Custom channels can be created from each sonar module’s
default channels; excluding Auto channels. This enables some
settings to be customized and saved as a separate channel.
These channels can then be assigned to individual Fishfinder
application panes. Up to 10 custom channels can be created for
each connected sonar module.
When changed the following settings are saved to the channel
that is currently displayed:
• Sensitivity settings
• Range settings
• Frequency tuning — Only 2 frequency settings can be saved
per transducer / sonar module combination.
Note: Performing a Sonar Reset will erase all custom
channels for the current sonar module.
Creating a custom channel
To create a custom channel follow the steps below.
From the Fishfinder application menu:
1. Select Channel .
The Channel selection page is displayed.
2. Select the tab for the sonar module you want to create a
custom channel for.
3. Select the Channel options icon located next to the channel
that you want to use, or
4. using non–touch controls, select the channel and then press
and hold the Ok button until the options screen is displayed.
5. Select Copy Channel .
The on-screen keyboard is displayed.
6. Enter the name you want to assign to your new channel.
7. Select SAVE .
The new channel is now available in the channel list for the
relevant sonar module.
8. Select the new channel to display it in the Fishfinder
application pane.
Changes made to the Sensitivity, Range or Frequency tuning
settings are automatically saved to the channel displayed.
You can now assign the new channel to a Fishfinder application
pane.
Renaming custom channels
With the Channel selection page displayed:
1. Select the tab for the sonar module that contains the channel
you want to rename.
2. Select the Channel options icon next to the custom channel.
The custom channel options page is displayed
186
gS Series