Raven SCS 700, Инструкция по установке и обслуживанию

Страница: 43 / 72

39
3) Place MASTER ON/OFF switch to ON and BOOM ON/OFF switches to OFF.
4) Place all PRODUCT OFF/MAN/AUTO switches to OFF.
5) Place POWER ON/OFF switch to ON.
6) Verify correct Boom Widths, SPEED CALS, METER CALS, VALVE CALS, and RATE CALS have
been entered in the Console.
7) Run main carrier pump at normal operating RPM.
8) Verify that each BOOM ON/OFF Valve operates and that no nozzles are plugged by operating Boom
ON/OFF switches. (MASTER switch must be ON).
9) Enter a SELF TEST speed equal to that of normal operating speed, verify entry by depressing
SPEED (6 MPH [9.6 km/h] is recommended). (See Self Test mode under "SPEED" in "OTHER
DISPLAY FEATURES").
10) Place all BOOM ON/OFF switches to ON.
11) Place PRODUCT 2-OFF/MAN/AUTO switch to MAN, the PRODUCT 2 display should display
a reading.
12) Verify that by operating the injection PRODUCT 2 INC/DEC switch, that injection PRODUCT 2 can
be varied over a wide range above and below the desired application rate in oz/acre [dl/ha]. Then
set injection PRODUCT 2 for normal oz/acre [dl/ha] of application.
13) Repeat Steps 11 and 12 for each Product in use.
14) Place OFF/MAN/AUTO switch for each Product in use to AUTO. The system will seek the
programmed injection PRODUCT RATE CAL.
15) Enter a SELF TEST speed 2 MPH [3.2 km/h] greater than that initially programmed (8.0 MPH)
[12.9 km/h]. The system will automatically correct for this speed variation.
16) Turn one BOOM ON/OFF switch to OFF position. The system will automatically correct for this
change in boom lengths.
17) Repeat Steps 11 thru 16 for all remaining injection products.
17) Drain water from Injection Module Tank and add product.
18) To verify at any time that the Injection Pump is properly calibrated, refer to Appendix 11.
PREVENTIVE MAINTENANCE
Preventive maintenance is most important to assure long life of the system. The following maintenance
procedures should be followed on a regular basis: