Raven RoGator 64 Series, Руководство по установке

Страница: 65 / 80

5
Manual No. 016-0230-044 Rev. F 61
ULTRAGLIDE
120’ BOOM
FIGURE 11. 120’ Boom Gauge Wheel Installed
1. Remove the nuts from the right wheel axle (P/N 063-0131-585).
2. Place the wheel (P/N 322-0131-003) on the right wheel axle.
3. Align and place the hub retainer bracket (P/N 107-0171-617) over the wheel.
4. Reinstall the light nuts on the wheel axle to secure the wheel and hub retainer bracket.
5. Secure the receiver bracket (P/N 116-0159-707) to the boom tube using four 1-9/16” x 2-1/2” L x 3/8” thread U-
bolts (P/N 107-0171-611) and eight 3/8” - 16 flanged lock nuts (P/N 312-1001-164).
6. Insert the right wheel axle assembly into the mounting receiver bracket, positioning it so that the bottom of the
wheel touches, or is close to touching, the ground and the wheel faces away from the machine.
7. Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2” - 13 x 1-1/2 SS hex bolts
(P/N 311-0058-186) and two 1/2” zinc hex nuts (P/N 312-1001-043).
8. Repeat the steps above to install the left gauge wheel on the front of the left boom.
INSTALL THE ULTRAGLIDE WIRING
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on
both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and
wires.
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.