Raven ISO Product Controller II, Руководство по эксплуатации

Страница: 36 / 138

C
HAPTER
4
26 ISO Product Controller II and Hawkeye Operation Manual
DISPLAY SMOOTHING
Enable Display Smoothing to display target rate as actual rate when the rate is within 10% of the target rate. Actual
rate will be displayed if the rate controller does not reach control deadband within ten seconds.
AUTO SECTION CONTROL
Allows section control in reference to coverage maps. When enabled, section control will automatically turn off an
active section as it enters an area where product has been previously applied. As the section leaves the previously
applied area, the section control feature turns the section back on.
NOTE: A task controller or UT capable of automatic section control is required to allow the Hawkeye
®
system
to control sections automatically. If auto section control is not enabled, automatic section control
commands from the task controller will be ignored. Refer to the manufacturer operation guides and
materials for information on utilizing this feature.
• If the UT is capable of automatic section control and the section control feature is available in the Hawkeye
®
Tools Menu, select the feature by placing a check mark in the corresponding box to enable the feature.
• If the UT is capable of automatic section control, but the section control feature is not available in the
Hawkeye
®
Tools Menu, the feature must be enabled from a different UT menu. Review the UT operation
manual for assistance with the section control or task controller options.
• If the UT is not capable of automatic section control, Hawkeye
®
will not automatically control sections
regardless of the state of the section control feature on this screen. It is recommended to de-select or disable
this feature when operating the Hawkeye
®
system without automatic section control.
EXTERNAL/RX CONTROL
Enable External/RX Control to allow the field computer to modify target application rate based on prescription
map and/or the task controller on-screen rate entry fields.
Refer to the UT operation manual for assistance with loading and selecting prescription rate information for field
applications.
PWM HIGH SIDE DRIVE
Enables the valve driver to modulate the high side of the PWM valve and provide a constant ground return.
Typically selected when using a PWM Boost Box.
ENABLE TURN COMPENSATION
The turn compensation feature automatically adjusts individual nozzle duty cycles when turning. The lowest NCV
duty cycle should match Minimum Nozzle PWM value for innermost operating NCV in a turn. The highest NCV
duty cycle may not be 100% due to maximum output capabilities of the NCV with a given tip size and system
efficiency.
TURN COMPENSATION CALIBRATION
If the Hawkeye
®
Product Controller II ECU mounting position is modified or adjusted, recalibrate turn
compensation to ensure the feature correctly adjusts nozzle rates during applications and ensure that the Product
Controller II ECU orientation is configured properly.
NOTE: The Product Controller II ECU orientation is calibrated during the initial system calibration wizard. To
recalibrate the Product Controller II ECU gyro, restart the calibration wizard or perform the following
procedure.