Retractable Flap Barrier Operation Manual
25
- -
1.
First check the reduction ratio of the entire system and then set the value of the
corresponding NP08. The NP08 setting method is as follows:
This value is calculated as the motor gearbox reduction ratio * output gear
reduction ratio / 15 (system default motor selection 30 ratio)
2.
Set the door opening angle by adjusting the values of DP06 and DP07.
7. The main and auxiliary machines open in the opposite direction.
Solution:
1. Set the value of NP07 to change the forward and reverse rotation of the motor.
8, after the system is set up, the arm Retractable Flaps the chassis when the power
is turned off, and you cannot find the zero position yourself.
Solution:
1. Change the left and right limit.
9. Whether the main board can control the anti-collision movement with clutch.
Solution:
1. The main board is in the Retractable Flap Barriers main board mode, and the
parameters of DP09 can be changed.
10, do not need voice broadcast, need a buzzer alarm
Solution:
1. The main board is in the Retractable Flap Barriers main board mode, and the
parameter of LP03 is changed to 2.
11. When the Retractable Flap arm switch is in place, the Retractable Flap arm is
shaken badly.
Solution:
