Retractable Flap Barrier Operation Manual
23
- -
installing the magnet. The size of the gap between the magnet and the limit plate
should be about 5 mm. The magnet has N/S pole magnet fixed and the
corresponding limit will not be bright. )
2, the main and auxiliary machine communication line connection, (the channel
installation must ensure a motherboard a sub-board (the main board marked with
Z, the sub-board marked with F) main board can be set by NP09)
3.
Power up to set the zero position after the system is started (DP03)
4.
Check whether the Retractable Flap Barriers is consistent by opening the door.
5, through the actual situation setting NP07 set the motor's forward and reverse
(main and auxiliary boards are required)
6.
After the power is cut off, the Retractable flap arm automatically opens the door.
7.
After the power is turned on, the Retractable Flap arm automatically returns to
the zero position (if it cannot automatically return to the zero position and the limit
position is changed)
8, set the door opening angle (DP06, DP07)
The above specific parameters can be viewed through menu items to see the
specific meaning.
Second, wing gate debugging
1. Fixed limit (can adopt traditional wing gate limit (PNP)
2, the main and auxiliary machine communication line connection, (the channel
installation must ensure a motherboard a sub-board (the main board is marked
with Z, the sub-board is marked with F)
3. The board defaults to Retractable Flap Barriers mode. Set the wing gate mode
by long pressing the INC key to change the value of NP01 (both main and sub-
boards are required).
