Ravel RE-900, Инструкция по установке, пусконаладке и эксплуатации

Страница: 47 / 53

46 RE / DD / UM / RE-900 1.0-0
The LCD shows as follows. If there is more than one fire, the number
of zones in fire (shown as (Z##)) and in which zone first or recent fire
(Shown as Z##) occurred will be displayed on the fire screen.
Where A – n th Fire; B – Total No. of Fire; X – Zone Number which is
shown in LCD at present
The External hooter will be silenced by using the
Silence Key and
silenced LED indicates it. But the buzzer tone will change to toggle
tone from continues tone.
Always the recent fired zone FIRE LED will blink continuously, rest of
the fired zone FIRE LED’s will glow constantly till it goes to RESET.
The
FIRE LED indication will remain ON condition till the panel is RESET.
Note:
1.
The Fire and Fault relay will be in ON condition till the fire
and fault LED’s go OFF.
2. By silencing, hooters are switched off and relay output for
actuators will remains in ON Condition until reset.
3. Always Recent fire zone LED will blink.
4. The other fire zones can viewed by using the key ‘*’.
5.3.3 ZONE Disable/W.T:
Disable: The any Zone can be Disabled / Enabled in zone
mode through the programming section 4.2.1 Page 35 . The ON
status indicates, the zone is disabled and the OFF status of the LED
indicates the enabled and blinking of that LED indicates the zone is
in walk test mode. In LCD the suppressed events are viewed in
suppressed events from menu screen.
[A/B]
FIRE IN ZONE X
Zone Location
Fault [XX/YY]
Zone X Disabled