Ravel RE-900, Инструкция по установке, пусконаладке и эксплуатации

Страница: 40 / 53

39 RE / DD / UM / RE-900 1.0-0
In AC Loss Delay is enabled condition, to change the time
press enter key and use left /right key to increase/ decrease the
timing.
4.2.2.4.3 Advanced
By selecting the number 3 from the Screen, it system enters into
the Advanced setting mode. It required the configuration
password. In this mode the system up gradation like Network
selection, Changing the configuration password & Factory
resetting can be done. The default configuration password is
“654321”. After entering into the mode, screen will be shown as
below.
1. Communication
2. Password Control
3. Factory Default
[Adv anced]
By selecting the number 1 from the Advanced screen, the system
enters into communication mode. In this mode, network and
repeater configuration can be done. After entering into this mode,
screen will be as below.
1. Netw ork
2 .Repeater Config
[Common]
4.2.2.4.3.1.1
By selecting the number 1 from the Communication screen, the
system enters into communication mode. After entering into this
mode, screen will be as below.
1. N/W Addr:
2. Netw ork Status
3. N/W O/P Config
[N/W]
4.2.2.4.3.1.1.1 Network Address
By selecting the number 1 from the network screen, the system
enters into the network address changing mode. In this mode the
address of the panel shall be changed using the alphanumeric key