Ravel RE-900, Инструкция по установке, пусконаладке и эксплуатации

Страница: 41 / 53

40 RE / DD / UM / RE-900 1.0-0
pad. The address of the panels should be in the range 1 to 32. After
entering into this mode, the screen will as shown below.
N/W Addr ?
[N/W Addr]
Note: Make sure the address of the panel is not repeated.
4.2.2.4.3.1.1.2 Network Status
By selecting the number 2 from the network screen, the system
enters into the network status mode. In this mode the network
selection can be enabled / disabled by using up and down arrow
keys in the selected panel address. After entering into this mode,
screen will as shown below.
En ter Pa nel No: ?
[Mode]
Pane l No: 4
Enab le
[Edit]
[N.W Pane l]
4.2.2.4.3.1.1.3 Network Output Config
By selecting the number 3 from the network screen, the system
enters into the network Output configuration. After entering into this
mode, screen will as shown below.
1) Fire O.P:Disabled
2) Fault O/P: Disabled
3) NAC's : Disabled
[N/W O/P *]
4.2.2.4.3.1.2 Repeater Configuration
The Repeater configuration is used to configure the repeater panel.
The repeater panel can be enable or disable by switching the # key.
The LCD display of the screen is shown below.
Ente r Rep. Pan el No?
[Re p Co nf ig ]
Re pea ter Pa nel No : 05
Disab led
[ # Ed it]
[Re p Pnl] Rep eate r Pan el No : 0 5
Ena ble
[# Edit]
[Rep Pnl]
#
4.2.2.4.3.2 Password Control
By selecting the number 2 from the advanced screen, the system
enters into the password control. In this stage user & Advance
password can be reset. After entering into this mode, screen will as
shown below.