RAM 2500 2019, Руководство пользователя

Страница: 56 / 332

GETTING TO KNOW YOUR VEHICLE
54
Reprogramming A Single HomeLink Button
(Canadian/Gate Operator)
To reprogram a channel that has been previ -
ously trained, follow these steps:
1. Cycle the ignition to the ON/RUN posi -
tion.
2. Press and hold the desired HomeLink
button until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button, proceed
with “Canadian/Gate Operator Program -
ming” step 2 and follow all remaining
steps.
Using HomeLink
To operate, push and release the
programmed HomeLink button. Activation
will now occur for the programmed device
(i.e. garage door opener, gate operator, secu
-
rity system, entry door lock, home/office
lighting, etc.) The hand-held transmitter of
the device may also be used at any time.
Security
It is advised to erase all channels before you
sell or turn in your vehicle.
To do this, push and hold the two outside
buttons for 20 seconds until the orange indi
-
cator flashes. Note that all channels will be
erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is
disabled when the Vehicle Security Alarm is
active.
Troubleshooting Tips
If you are having trouble programming
HomeLink, here are some of the most
common solutions:

Replace the battery in the Garage Door
Opener hand-held transmitter.

Push the LEARN button on the Garage
Door Opener to complete the training for a
Rolling Code.

Did you unplug the device for program -
ming and remember to plug it back in?
If you have any problems, or require assis -
tance, please call
toll-free1-800-355-3515or, on the Internet
at
HomeLink.com for information or assis -
tance.
General Information
The following regulatory statement applies to
all Radio Frequency (RF) devices equipped
in this vehicle:
This device complies with Part 15 of the FCC
Rules and with Innovation, Science and
Economic
Development Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause harmful inter -
ference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli
-
ance could void the user’s authority to
operate the equipment.
INTERNAL EQUIPMENT
Electrical Power Outlets
The auxiliary 12 Volt (13 Amp) power outlet
can provide power for in-cab accessories
designed for use with the standard “cigar
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 54