RAM 2500 2019, Руководство пользователя

Страница: 51 / 332

49
Relearn Procedure
For vehicles equipped with a sunroof, there
is a relearn procedure that allows you to cali -
brate the sunroof when the “Express Opera -
tion” feature stops working. To reset the
sunroof, follow these steps:
1. Set the ignition to the ACC or the ON/
RUN position.
2. Ensure that the sunroof is in the fully
closed position.
3. Push and hold the close switch. The
sunroof will hit the hard stop and move to
the vent position after ten seconds.
4. Release the close switch.
5. Push and hold the close switch again within
five seconds to begin the teaching process.
The sunroof will complete one full cycle
and return to the fully closed position.
NOTE:
If the close switch is released anytime during
the teach cycle, the procedure will need to
be repeated starting from the first step.
6. Once the sunroof has stopped in the fully
closed position, release the close switch.
The sunroof is now reset and ready to
use.
HOOD
To Open The Hood
To open the hood, two latches must be
released.
Hood Release Lever Location
1. Pull the hood release lever located below
the steering wheel at the base of the
instrument panel.
2. Reach into the opening beneath the
center of the hood and push the safety
latch lever to the left to release it, before
raising the hood.
Safety Latch Location
To Close The Hood
Lower the hood to approximately 12 inches
(30 cm) from the engine compartment and
drop it. Make sure that the hood is
completely closed.
WARNING!
Be sure the hood is fully latched before
driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is
in motion and block your vision. Failure to
follow this warning could result in serious
injury or death.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 49