RAM 2500 2019, Руководство пользователя

Страница: 54 / 332

GETTING TO KNOW YOUR VEHICLE
52
rapidly after HomeLink has received the
frequency signal from the hand-held
transmitter. Release both buttons after
the indicator light changes from slow to
rapid.
5. At the garage door opener motor (in the
garage), locate the “LEARN” or
“TRAINING” button. This can usually be
found where the hanging antenna wire is
attached to the garage door opener/
device motor. Firmly push and release
the “LEARN” or “TRAINING” button. On
some garage door openers/devices there
may be a light that blinks when the
garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the
next step after the LEARN button has been
pushed.
6. Return to the vehicle and push the
programmed HomeLink button twice
(holding the button for two seconds each
time). If the garage door opener/device
activates, programming is complete.
NOTE:
If the garage door opener/device does not
activate, push the button a third time (for
two seconds) to complete the training.
To program the remaining two HomeLink
buttons, repeat each step for each remain
-
ing button. DO NOT erase the channels.
Reprogramming A Single HomeLink Button
(Rolling Code)
To reprogram a channel that has been previ -
ously trained, follow these steps:
1. Cycle the ignition to the ON/RUN posi -
tion.
2. Push and hold the desired HomeLink
button until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button proceed
with “Programming A Rolling Code” step
2 and follow all remaining steps."
Programming A Non-Rolling Code
For programming Garage Door Openers
manufactured before 1995.
1. Cycle the ignition to the ON/RUN posi -
tion.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program
while keeping the HomeLink indicator
light in view.
3. Press and hold the HomeLink button you
want to program while you press and hold
the hand-held transmitter button.
4. Continue to hold both buttons and
observe the indicator light. The Home -
Link indicator will flash slowly and then
rapidly after HomeLink has received the
frequency signal from the hand-held
transmitter. Release both buttons after
the indicator light changes from slow to
rapid.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 52