RAM 2500 2019, Руководство пользователя

Страница: 55 / 332

53
5. Press and hold the programmed Home -
Link button and observe the indicator
light.

If the indicator light stays on
constantly, programming is complete
and the garage door/device should
activate when the HomeLink button is
pressed.

To program the two remaining Home-
Link buttons, repeat each step for
each remaining button. DO NOT erase
the channels.
Reprogramming A Single HomeLink Button
(Non-Rolling Code)
To reprogram a channel that has been previ -
ously trained, follow these steps:
1. Cycle the ignition to the ON/RUN posi -
tion.
2. Press and hold the desired HomeLink
button until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button, proceed
with “Programming A Non-Rolling Code”
step 2 and follow all remaining steps.
Canadian/Gate Operator Programming
For programming transmitters in Canada/
United States that require the transmitter
signals to “time-out” after several seconds of
transmission.
Canadian radio frequency laws require trans -
mitter signals to time-out (or quit) after
several seconds of transmission – which may
not be long enough for HomeLink to pick up
the signal during programming. Similar to
this Canadian law, some U.S. gate operators
are designed to time-out in the same
manner.
It may be helpful to unplug the device during
the cycling process to prevent possible over
-
heating of the garage door or gate motor.
1. Cycle the ignition to the ON/RUN posi -
tion.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program
while keeping the HomeLink indicator
light in view.
3. Continue to press and hold the HomeLink
button, while you press and release
(“cycle”) your hand-held transmitter
every two seconds until HomeLink has
successfully accepted the frequency
signal. The indicator light will flash
slowly and then rapidly when fully
trained.
4. Watch for the HomeLink indicator to
change flash rates. When it changes, it is
programmed. It may take up to 30
seconds or longer in rare cases. The
garage door may open and close while
you are programming.
5. Press and hold the programmed Home -
Link button and observe the indicator
light.
NOTE:

If the indicator light stays on constantly,
programming is complete and the garage
door/device should activate when the
HomeLink button is pressed.

To program the two remaining HomeLink
buttons, repeat each step for each
remaining button. DO NOT erase the chan-
nels.
If you unplugged the garage door opener/
device for programming, plug it back in at
this time.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 53