51
NOTE:
Only use this transceiver with a garage door
opener that has a “stop and reverse” feature
as required by federal safety standards. This
includes most garage door opener models
manufactured after 1982. Do not use a
garage door opener without these safety
features. Call toll-free 1-800-355-3515or,
on the Internet at
for safety
information or assistance.
Before You Begin Programming
HomeLink
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accu
-
rate transmission of the radio-frequency
signal it is recommended that a new battery
be placed in the hand-held transmitter of the
device that is being programmed to the
HomeLink system.
To erase the channels, place the ignition in
the ON/RUN position, and push and hold the
two outside HomeLink buttons (I and III) for
up to 20 seconds or until the orange indi
-
cator flashes.
NOTE:
Erasing all channels should only be
performed when programming HomeLink
for the first time. Do not erase channels
when programming additional buttons.
If you have any problems, or require assis
-
tance,
please
call
toll-free
1-800-355-3515 or, on the Internet at
for information or assis
-
tance.
Programming A Rolling Code
For programming garage door openers that
were manufactured after 1995. These
garage door openers can be identified by the
“LEARN” or “TRAIN” button located where
the hanging antenna is attached to the
garage door opener.
NOTE:
It is NOT the button that is normally used to
open and close the door. The name and color
of the button may vary by manufacturer.
1. Place the ignition in the ON/RUN posi
-
tion.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program
while keeping the HomeLink indicator
light in view.
3. Push and hold the HomeLink button you
want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and
observe the indicator light. The Home
-
Link indicator will flash slowly and then
WARNING!
Your motorized door or gate will open
and close while you are programming the
universal transceiver. Do not program
the transceiver if people, pets or other
objects are in the path of the door or
gate. Only use this transceiver with a
garage door opener that has a “stop and
reverse” feature as required by Federal
safety standards. This includes most
garage door opener models manufac
-
tured after 1982. Do not use a garage
door opener without these safety
features.
Vehicle exhaust
contains carbon
monoxide, a dangerous gas. Do not run
your vehicle in the garage while program
-
ming the transceiver. Exhaust gas can
cause serious injury or death.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 51
Содержание 2500 2019
Страница 1: ...2019 USER GUIDE RAM 2500 3500...
Страница 330: ......
