SV-360HD 3D Camera System
19
SV-360HD 3D Camera Installation/Configuration Guide
Radio Engineering Industries, Inc. | 6534 L Street | Omaha, NE 68117
© 2018 Radio Engineering Industries, Inc.
800.228.9275 | p: 402.339.2200 | f: 402.339.1704 | radioeng.com
3
Camera Configuration
Configuration of the cameras can be performed after the camera system has been successfully
installed.
3.1
Set the Calibration Parameters
A bus will typically be surrounded with a total of 24 camera calibration points. The points are outlined
alongside and at both ends of the vehicle and are identified with round foam markers. A cone is placed
on calibration points three and four per camera calibration.
Note
Calibration settings can be imported and exported to be re-used on similar buses. This enables a
fleet of buses to receive consistent calibration settings for each vehicle.
The manufacturer recommends exporting calibration data immediately after system calibration is
completed. This will prevent having to start the calibration process all over again in the event of system
failure and recovery of calibration settings would be necessary. Saving the calibration settings would
enable the installer of the new system to just download the legacy data into the replacement system.
Aiming Kit Components
Aiming Kit
An optional Aiming Kit (PN 750403) is recommended to enable the most accurate camera calibration.
The kit consists of the following:
•
100-foot tape measure
•
A pair of 31-inch 3D Target Cones
•
Angle finder
•
Set of 24 aiming targets
•
Calibration instructions (PN 640543)
