SV-360HD 3D Camera System
15
SV-360HD 3D Camera Installation/Configuration Guide
Radio Engineering Industries, Inc. | 6534 L Street | Omaha, NE 68117
© 2018 Radio Engineering Industries, Inc.
800.228.9275 | p: 402.339.2200 | f: 402.339.1704 | radioeng.com
2.1
Camera Installation Steps
1. Mark the pilot holes where the cameras will be mounted on the vehicle.
Determine the middle point of the bus and place the camera gasket at the point. Mark the point
and drill a ½-inch cable hole.
2. Continue using the camera gasket as a camera-mounting template and mark the pilot holes for
mounting the camera. After marking the points, drill
⅛-inch holes on the pilot points.
3. Mount the Cameras
•
Run the cable through the cable hole on the vehicle, place gasket on the camera base, and
plug the cable into the camera.
Note:
The photo sensor is located on the bottom view of the camera and the mounting orientation of
the camera should have the sensor pointed as close to the vehicle as possible.
•
Line up the camera with the mounting pilot holes and run the mounting screws through the
camera mounting holes and into the vehicle.
•
After the camera is fastened to the vehicle, aim the camera lens vertical to the vehicle 45°
and lock the angle in place by installing the camera housing.
4. Route Wiring Inside Vehicle
•
Route wiring from the cameras to the control module.
•
All cables should be gathered to the control module.
•
Refer to the wiring diagram for more details.
•
Take note of the color and connector size of each extending cable.
2.2
Install the Control Module
Note:
It is recommended that the control module is installed inside/behind the tool cabinet. This will
make it easier to remove the TF Card or USB Disk.
1. Remove the panel from the control module and connect the HDMI cable of the LCD monitor or
other display screen.
2. Install the control module. If in IR Mode, put the infrared receiver in a position facing the general
direction of the operator. Use the 3M stick tape on the bottom the IR receiver to secure it to the
mounting surface.
