![background image](http://html1.mh-extra.com/html/racom/ripex/ripex_user-manual_3186409164.webp)
Manual
– Values can be set manually.
Hello packet period [s]
Default = 60 sec, [Max=3600]
When the set period expires, the next Hello packet is transmitted. To avoid the collisions,
there is a jitter of approx. 5%.
Hello packet success rate [%]
List box: possible values
Default = 87.5
When succes rate of Hello packets drops bellow this threshold, the unit switches to the next
alternative gateway in the line. Hello packet success rate evaluation is based on last 8
transmitted Hello packets. (The info about successfully delivered outbound Hello packets
are carried by received Hello packets).
RSS [-dBm]
Default = Off [255= Off]
Hello packets carry the info about average RSS (saved in respective Statistic table) on each
radio hop on its way. When any RSS on the way is lower than the set one, the unit switches
to the next alternative gateway in the line. Each individual packet is evaluated.
Test when lower priority
NOTE: This menu item has been renamed to improve understanding. It read "Lower priority
path checking" until FW ver. 1.4.x.x. Its functionality has NOT been changed.
List box: On/Off
Default = On
If On, the alternative path is tested, even if it is lower priority than the currently active one
(Hello packets are transmitted). Advantage – if the active path fails, system switches only to
a functional alternative. Disadvantage – when e.g. GSM for backup is used, Hello packets
used for testing are charged. When Off, the respective alternative path is tested only when
its priority is higher than that of the active path.
NOTE 1: The number of Backup paths is not limited. The number of Alternative routes is min.2 and
max. 16 (active ones). There can be more than 16 Alternative routes defined, only the active ones are
tested.
NOTE 2: When Optimization (Settings/Radio/Optimization) is "On", UDP packets with both source and
destination port 8886 are not transferred over the network, they are discarded in the end RipEX. UDP
packets with source port 8903 are not optimized, even if Optimization is "On".
NOTE 3: When SW key Backup routes or Master key expires, Backup path configuration is lost.
Buttons
Apply
- applies and saves the changes.
Cancel
- restores original values.
Find
- finds (highlights the respective line in the table) the route for a specific IP address if exists.
Check routing
- highlights duplicate routes for specific IP if they exist.
Backup status
- refresh the status of backup routes (Good, Failure, Unknown, Currently used)
RipEX Radio modem & Router – © RACOM s.r.o.
164
Advanced Configuration
Содержание RipEX
Страница 2: ......
Страница 42: ... DQ Data Quality Min 180 PER Packet Error Rate Max 5 RipEX Radio modem Router RACOM s r o 42 Network planning ...
Страница 222: ...Fig 10 3 ATEX Certificate RipEX 2 3 RipEX Radio modem Router RACOM s r o 222 Safety environment licensing ...
Страница 223: ...Fig 10 4 ATEX Certificate RipEX 3 3 223 RACOM s r o RipEX Radio modem Router Safety environment licensing ...