RACOM RipEX, Руководство пользователя

Страница: 131 / 234

TX Buffer
Queue length
Queue size [kB]
TX Buffer timeout
TX Buffer timeout [s]
Others
Radio ARP timeout [min]
■ IP*
Default = 10.10.10.169
IP address of Radio interface
■ Mask*
Default = 255.255.255.0
Network Mask of Radio interface
■ TX frequency**
Transmitting frequency. Format MHz.kHz.Hz. Step 5 (for 25 kHz channel spacing) or 6.25 kHz (for
12.5 or 6.25 kHz channel spacing).
The value entered must be within the frequency tuning range of the product as follows:
RIPEX-135: 135-154 MHz
RIPEX-154: 154-174 MHz
RIPEX-300: 300-320 MHz
RIPEX-320: 320-340 MHz
RIPEX-340: 340-360 MHz
RIPEX-368: 368-400 MHz
RIPEX-400: 400-432 MHz
RIPEX-432: 432-470 MHz
RIPEX-470: 470-512 MHz
RIPEX-928: 928-960 MHz
■ RX frequency**
Receiving frequency, the same format and rules apply.
NOTE: By default, the TX and RX frequencies are locked together and change in one field is mirrored
in the other. If clicked, the lock is removed and different TX and RX frequencies can be entered.
■ Channel spacing [kHz]**
List box: possible values
Default = 25 kHz
The wider the channel the higher the possible Modulation rate.
NOTE: The 50 kHz channel spacing is available only for HW versions of Radio board higher than
1.1.90.0 or 1.2.50.0. See Status/Radio/HW version.
■ RF power [W]**
List box: possible values
Default = 5 W
The range of values in the list box is limited to 2 W for high Modulation rates. 10 W is available only
for lower Modulation rates (CPFSK) and only when the corresponding SW feature key is active.
131 © RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration