10
/ 28
User Manual
Rev. 1.0 - 29/11/16
BLUES30/50NV
ELETTRONICA
√
For operating tests only: dummy load with 50 Ohm impedance and adequate
capacity (30/50W minimum).
√
Connection cable kit including:
• Mains power cable
• Coaxial cable with BNC connectors for interlock signal connection
• RF cable for output to load / antenna (50 Ohm coaxial cable with N-type
connector)
• Audio cables between transmitter and audio sources.
5.1.2 Connections
Connect the RF output of the transmitter to the antenna cable or a dummy load
capable of dissipating amplifier output power. To begin with, set exciter to minimum
output power and switch it off.
Connect the transmitter INTERLOCK IN input to the matching INTERLOCK OUT
output fitted on R.V.R. Elettronica equipment to act as hybrid couplers. If your
equipment is a different brand, identify an equivalent output.
Figure 5.2:
connections with amplifier
WARNING: Electric shock hazard! Never handle the RF output connector
when the e�uipment is powered on and no load is connected. Injury or death
may result. .
Ensure that the POWER switch on the front panel is set to “
OFF
”.
Connect the mains power cable to the MAINS connector on the rear panel.
