BLUES30/50NV
ELETTRONICA
17
/ 28
User Manual
Rev. 1.0 - 29/11/16
The pressure of encoder when the display is switched on, while you are in the
predefined menu (menu 1), serves in order to shown the following
selection screen
(menu 3) from which you can access to all the other menus:
Menù 3
If you instead want to go back to the predefined menu, is sufficient select the
ESC
entry then push the encoder.
If the temperature alarm is enabled, the power supply will come inhibited in case
of alarm threshold overcoming, and it will have displayed the following window
only in case you are in the predefined screen:
State 1
Once restored the normal operation conditions, the power supply will come
rehabilitated with the same modalities antecedent the alarm.
If the modulation ran out, under 20 kHz, for a time of about 5 minutes (not
modifiable) the NO AUDIO status comes displayed in the predefined screen, but
the power does not comes inhibited.
State 2
To gain access to a submenu, select menu name (name is highlighted by cursor)
using button or and press the encoder.
5.4.1 Operation Menu (Fnc)
From this menu the user can enable or disable the exciter
power supply
, set
the
deviation display modality
and set up the percentage of
Forward
(
PgD
) or
Reflected Power Good
(
PgR
).
