120346 Rev. B
23
Q Xi
i. ARMREst REcEiVER AttAchMEnt
1. Mounting
a.
Place armrest receiver hardware with clamp (B) onto the side frame.
b.
Using a 10mm wrench install fasteners (D) . torque to 144 in-lbs.
c.
install armrest into receiver (A) to ensure proper alignment. loosen and retightened fasteners (c) as
needed.
d
Repeat process to opposite side.
2. Adjustment
a.
to adjust the fit of the single Post Armrest in the receiver, loosen the 4 hex bolts (c) by using a 10mm
wrench.
b.
With the armrest assembly in the receiver (A), press firmly on the outside of the receiver.
c.
Maintain pressure on the receiver and re-tighten two of the hex bolts (c).
d.
Remove the armrest assembly and re-tighten the remaining two hex bolts(c).
e.
the armrest will fit firmly in the receiver and lessen any noise that may result from vibration.
J. PADDED sWing-AWAY ARMREsts
1. Mounting and height adjustment
a.
swing-away armrests(F) can be detached or can swing away to allow lateral transfers. they are height
adjustable (1" increments) by moving bolt (E) up or down in predrilled holes on armrest bracket.
b.
Additional height can be achieved by removing bolts (g) and moving the receiver(h) or the entire
hardware assembly up or down the rear frame tube. Ensure bolts (g) are retightened
(torque to 144 in lbs).
43
39
40
41
42
IX. DEALER SERVICE AND ADJUSTMENT
41
40
42
43
39
A
B
D
E
F
g
h
A. Receiver
B. clamp
c. Receiver adjustment hardware
A
B
c
c
c
c
A
Содержание QXi
Страница 19: ...120346 Rev B 19 QXi NOTES...
