Quantum Scalar 50, Руководство пользователя

Страница: 44 / 290

Chapter 1 Library Description
Getting Started
Quantum Scalar 50 User’s Guide 20
1 The Scalar 50 tape drives and system controller board are accessed
from the back of the library (refer to
Connecting to Host
Workstations on page 31).
2 Connect Ethernet port located on the back of the library on the
system controller board to the local area network (see
figure 9 ).
Figure 9 Connecting the
Library to the Local Area
Network
Ethernet port System controller board Internal communication
with TC2201 CPCI card
Loading Tape Cartridges
1
Before operating the library, load the appropriate tape cartridges (LTO or
SDLT) into the library starting with the left-hand magazine (see
figure 2
and figure 3 for slot locations).
Initial Configuration
1
The Quantum Scalar 50 must be initially configured with an IP address
before the remote management software is available. Refer to
Using the
OCP on page 37 for information on configuring your Scalar 50 network
information and preparing for operation.