Quantum Scalar 50, Руководство пользователя

Страница: 233 / 290

Appendix C Installing the Scalar 50 Library
Installing the Library
Quantum Scalar 50 User’s Guide 209
b Remove the hand restraint from the library.
Caution: Avoid touching the printed circuit board.
Caution: When removing the hand restraint, ensure that the
robotics umbilical cable is lying down in the correct
position inside the platform and not across the
robotics track.
c
Store the thumb screws and the restraining bolt in the hand
restraint.
d Install the tape cartridge magazines.
e Close the front doors.
6 Turn on the library by pushing power button located on the bottom
left-hand corner of the OCP (see
figure 117 ).
7 The OCP asks you:
“Are the Shipping Restraints Removed?”
(
YES
or
NO
).
8 Press
YES
to continue.
9 The OCP asks again:
“Are you sure the Hand & Thumb Screw Restraints have been
Removed?”
(
YES
or
NO
).
10 Press
YES
to continue. The library continues the boot process. When
complete, the
Home
screen displays.
11 Press Setup from the Home screen. The OCP displays the Setup
screen (see figure 118 ):
Note:
If the library encounters difficulties during the boot
process, there may be obstructions inside the library. The
the OCP will display:
"Please Remove Restraining Bolt, or
Hand Restraint. See User's Guide.”
Shut down the library,
open the doors with the emergency access tool and check
for obstructions. Be sure to check for the restraining bolt
on the left side of the cabinet.