Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 187 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Array or Expansion Module Hard Drives
Quantum DXi6902 User’s Guide 163
7 Turn on the system (see Turning On and Shutting Down the System
on page 21).
8 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see Factory Detect Hardware on page 40).
9 In the remote management console, delete any administrative alerts
and close any service tickets.
Replacing Array or Expansion Module Hard Drives
This section describes how to remove and replace hard disk drives
(HDDs) in the DXi6902 Array modules (RBODs) and Expansion modules
(EBODs) and contains the following sections:
• Obtaining a Replacement Array or Expansion Hard Drive
• Replacing an Array or Expansion Hard Drive
Note: DXi6902 hard disk drives are hot-swappable. You do not need
to shut down the system to remove and replace a drive.
Caution: Powering down the system incorrectly or removing the
wrong drive during a drive failure can result in potential
data loss. Do
not
power down the system to replace a hard
drive. Make sure you remove the failed drive and not a
good drive.
Obtaining a
Replacement Array or
Expansion Hard Drive
Before beginning the replacement procedure, make sure that you have
the required replacement kit. The appropriate replacement drive will be
provided by Quantum Customer Support (see Figure 97 ).
Caution:
Always make sure to use Quantum-supplied new drives as
replacement drives. Never insert a drive that was removed
from another system (not even another DXi6902 system).
You will need the following items to perform this procedure: