Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 188 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Array or Expansion Module Hard Drives
164 Quantum DXi6902 User’s Guide
• Replacement hard drive kit provided by Quantum Customer
Support.
• ESD grounding wrist strap (included in the replacement kit)
Figure 97 DXi6902 Array
Module (RBOD) or Expansion
Module (EBOD) Hard Drive
Replacing an Array or
Expansion Hard Drive
This section describes how to remove and replace a drive in a DXi6902
Array module (RBOD) or Expansion module (EBOD). Hard drives are pre-
assembled in hot-pluggable drive carriers that fit into the drive bays.
Caution: Do
not
remove a hard drive that has
not
failed. Instead,
only remove a drive that has failed. If you accidently
remove a good drive, wait 30 seconds before reinserting
the drive.
Caution: Use appropriate ESD precautions, including the use of a
grounding strap, when performing this procedure.
Removing and replacing a hard drive in an Array module (RBOD) or
Expansion module (EBOD) includes the following steps:
• Identifying a Failed Drive in an Array or Expansion Module
• Removing a Drive from an Array or Expansion Module
Illustration Description
Replacement hard drive
for DXi6902 Array
module (RBOD) or
Expansion module
(EBOD) (3.5 inch, 4TB)
PN 9-03802-01 (SED)
PN 9-03802-02
(non-SED)