Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 190 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Array or Expansion Module Hard Drives
166 Quantum DXi6902 User’s Guide
Figure 99 Array and Expansion
Hard Drive Carrier LEDs
Removing a Drive from an Array or Expansion Module
To remove the failed hard drive from a DXi6902 Array module (RBOD) or
Expansion module (EBOD):
Caution: You must replace the drive within three minutes after
removal to prevent the possibility of overheating the
equipment.
Caution: Bumping drives against another surface can damage the
drive mechanism or connectors. To avoid damage when
removing or installing a drive, always place your hand
under the drive to support its weight.
1 Carefully unpack the replacement drive and set it on a dry, level
surface near the Array module or Expansion module.
2 On the failed drive, pull the hard-drive carrier release handle to the
left (see Figure 47 ).
3 Slide the hard-drive carrier out until it is free of the hard-drive slot.
Drive service
action allowed
Drive active
Drive fault (solid amber
indicates drive failure)