Chapter 9: Configuration
Replication Configuration
Quantum DXi6900 User’s Guide
268
To configure DXi Accent:
1. To enable DXi Accent, select the
Enable Deduplication with Accent
check box.
Or to disable DXi Accent, clear the
Enable Deduplication with Accent
check box.
Note:
You cannot use DXi Accent if you are currently using NetBackup Accelerator or Optimized
Synthetic Backups. If you are using Accelerator, please make sure that Accent is not enabled. For
more information on using NetBackup Accelerator, see the
DXi-Series Configuration and Best
Practices Guide for NetBackup from Veritas
(6-67850).
2. Click
Apply
.
Additional Information
l
Click the
Change Encryption Type
link to change the OST data encryption type (see
).
l
To use DXi Accent, you must install the Quantum OST Client Plug-in on the media server. For
information about installing the OST Plug-in and using DXi Accent, see the
DXi-Series NetBackup
and Backup Exec OST Configuration Guide
(6-67079).
Replication Configuration
The
Replication Configuration
page allows you to configure and manage replication targets and allowed
replication sources on the DXi6900. A source
sends
replicated data to 1 or 2 targets, and a target
receives
replicated data from up to 10 sources. A DXi6900 can act as both a source and a target.
Additional Information
l
For more information about data replication, or to perform data replication, see
l
If the DXi is configured as a replication target
and
replication is performed across a public network,
with the source and target located behind NAT-enabled routers, you
must
specify a NAT IP address
for the DXi on the
Network
Configuring Interface IP Addresses on page 309
).
To access the
Replication Configuration
page, click the
Configuration
menu, and then click the
Replication
).
