Qilive Q. 6863, Руководство пользователя, Страница: 9 / 160

9
EN
if the temperature inside the freezer compartment drops obviously, it indicates the refrigeration
system is working normally.
4. Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will
be automatically controlled according to the user’s temperature setting. After the refrigerator
is fully cooled, put in foods, which usually need 2~3 hours to be fully cooled. In summer, when
the temperature is high, it takes more than 4 hours for the foods to be fully cooled (Try to open
the refrigerator door as less as possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground
wire and leakage circuit breaker are normal. If vibration noises are produced due to the
refrigerator contacting the wall or if the wall gets blackened by air convection around the
compressor, move the refrigerator away from the wall. Setting up the refrigerator may cause
jamming noise or image chaos to the mobile phone, fixed-line telephone, radio receiver,
television set surrounding it, so try to keep the refrigerator as far away as possible in such
case.
5.3. DOOR REVERSAL INSTRUCTION
Schematic diagram No. How to reverse the refrigerator door?
1
Screw off the screws of the upper hinge cover, and
then remove the upper hinge cover.
2
Install the communication cable into the junction box
on the top of the refrigerator.
3
Screw off the three bolts on the upper hinge, and then
remove the upper hinge.
4
Screw off the bolt on the left hole cover on the top of
the refrigerator, and then remove the hole cover.
5
Screw off the two bolts and one screw that fix the
middle hinge, and then remove the middle hinge.
6
Remove the screw cover, screw, and hole plug on the
left side of the refrigerator cabinet, and install them on
the right side of cabinet.
7
Screw off the screw of the trim strip cover, and remove
the trim strip cover.
8
Screw off the two screws of the door stopper, and
remove the door stopper.
9
Take out the left stopper (plastic) from the accessory
bag, install it on the other side of the door together with
the metal stopper removed from the right side, and
then fix them with two screws.
10
Take the trim cover out of the accessory bag, install it on
the right side of the door (put the door communication
line inside the trim cover), and fix it with screws.
11
Take out the left middle hinge from the accessory bag,
and fix it on the cabinet with two bolts and one screw.
12 Install the door onto the cabinet.
13
Take out the upper left hinge from the accessory bag,
fix it on the cabinet with bolts, and connect the wire
harness.
14
Take out the upper left hinge cover from the accessory
bag, and install it on the cabinet.
15
Install the hole cover on the top right side of the
refrigerator, and fix it with a bolt.