9. Every chaser consists of 24 steps by default, but you can reduce this value. To do so, with the
NEXT or PREV keys set the step number on the STEP display, you want to be the last one.
Press the END key, and then ENTER in the PROGRAMMING block.
7
3. With the NEXT or PREV keys select different step number (24 maximum) or adjust the
channels brightness for the first step. To do so, by pressing the appropriate CHANNEL keys
select the channels, where you want to set the brightness. If the channels are in a different
range, you can select the proper one with the PAGE CHANNEL "+" or "-" keys and press the
appropriate channel keys. Your selection will be confirmed by shining LEDs. The blinking LED
represents the channel selected in a different range.
4. Adjust the brightness of the selected channels with the sliders. The sliders affect the brightness
of channels in the currently selected range only.
5. You can deselect the channels by pressing the appropriate key again - the LED above will go
out. It also discards all the brightness changes made within this channel. If you want to discard
settings for all selected channels, press the SELECT ON/OFF key.
6. You can also select all 100 channels for programmming. To do so, when no LEDs are lit above
the CHANNEL keys, press the SELECT ON/OFF key and adjust the brightness for all the
channels needed with the sliders, paying attention to range selection.
7. After all the settings are made within the edited step, press the ENTER key in the
PROGRAMMING block.
8. To set the other chaser's steps, repeat the procedure from points 3 - 7.
Содержание PX125 Opera RedLine
Страница 1: ...INSTRUCTION MANUAL PX125 Opera RedLine R...