4. CONTROLLER AND DIMMERS CONNECTION
The Opera RL controller sends out the signals compatible with the DMX-512 standard. The
proper operation of the whole set of devices requires the correct DMX address settings in the
controlled devices and a correct devices' connection with a signal cable.
Below are some practical tips:
1. To connect the devices use of a 2-strand shielded microphone cable is recommended.
2. All the XLR couplings should be connected according to the following pattern:
pin 1 = shield
pin 2 = DMX-
pin 3 = DMX+
5. CONSOLE ACTIVATION
After switching the controller on (in NORMAL operation
mode) the controller's software version number is
displayed. In the example shown the software version
number is 1.02.
As the Opera RedLine software is permanently
improved, you can find the latest software version on the
producer's website. If its number is greater than
displayed, we recommend you to update your software.
The update process description and the software are
available on the www.pxm.pl website.
NOTICE:
By pressing any key you can enter the standard operation mode.
3
3. The controller and the effects must be connected in series, that is:
- the output of the controller to the input of the first effect,
- the output of the first effect to the input of the second effect,
- the output of the second effect to the input of the third effect, etc.
4. In the DMX OUT socket of the last effect the terminator must be installed
(XLR plug with the 110 Ohm resistor between 2 and 3 pins).
110 Ohm
resistor
11
0
Oh
m
1
3
PUSH
2
11
0
O
hm
dimmer no. 1
dimmer no. 2
last dimmer
CONTROLLER
SHIELD
SHIELD
DMX -
DMX +
DMX -
DMX +
1
2
3
PUSH
1
2
3
PUSH
1
2
3
PUSH
1
2
3
PUSH
2
1
3
2
1
3
2
1
3
terminator
Содержание PX125 Opera RedLine
Страница 1: ...INSTRUCTION MANUAL PX125 Opera RedLine R...