Pure Humidifier INTAC, Инструкция по установке и руководство по обслуживанию

Страница: 3 / 32

1
INTAC ® Specifications
Specifications
Supply Voltage: 24VAC ± 20% at 50/60 Hz, ± 1HZ, 9.33VA max.
Current Input Impedance: 93 Ohms
Voltage Input Impedance: 5000 Ohms
Minimum Output Voltage Impedance: 1kOhm
Maximum Output Current Impedance: 800 Ohm
Termination: Removable screw terminal block
Screw Termination Wire Size: 16 - gauge maximum
Maximum wire length to Tri - Probe: 50 feet*
Thermocouple Wire for Tank Temp Sensor When Used: Type K
Ambient Temperature Range: - 67ºF to 130ºF
Relative Humidity: 0 to 90% RH, non - condensing.
Vibration: 2g., 10 to 150 HZ., applied in any one of three axes.
Storage Temperature: - 40ºF to 158ºF
Limits, Ranges, Accuracy: Calibration accuracy and sensor conformity: ± 1% of Span, ± 1 LSD at 77ºF
±5ºF at rated line voltage ± 10 %
*For standard water units only . The Tri - Probe level sensor wiring is susceptible to interference
from wire - to - wire capacitance and wire - to - ground capacitance. For remotely mounted panels with less
than 20 feet of wire length for the Tri - Probe wires 18 - gauge thermostat wire may be sufficient. For
distances up to 50 feet it is best to use individual stranded 20 - gauge THHN wire with a minimum
insulation thickness of 0.030 inches run in a nonmetallic conduit. This conduit shall contain the three
Tri
- Probe wires only. The tank ground wire that terminates on plug J2 terminal #7 and all other low
voltage wiring shall be run separate from the Tri - Probe wires. Unshielded TIA Category 6 networking
cable may alternately be used, provided that the cable is not run inside a metal conduit or parallel to
and within 2 inches of a metal conduit or pipe for more than 10 feet. Furthermore, only one conductor
of each twisted pair is used for the probe wiring and the ground wire is also run separate from this wire
bundle. The other 5 wires in the bundle shall be cut and taped off on both ends so they do not short to
one another or to ground.