EDDYTHERM operating manual
8
These general instructions provide information and tips on operating the EDDYTHERM.
Numbers in red circles indicate the operating steps described in these instructions.
They must be performed in the order indicated.
This symbol indicates the connector for the temperature probe.
CE conformity and EMC
All versions of EDDYTHERM are in compliance with the EU Low Voltage Directive (2006/95/EC), the Electromagnetic
Compatibility Directive (EMC) (2004/108//EC), and the Machinery Directive (2006/42/EC):
EN 61000-6-1:2005-02; IEC 77/294/FDIS:2004
EN 61000-6-3:2005-06; IEC 61000-6-3:1996; VDE 0839-6-3:2005-06
EN 60519-1:2003
EN 60519-3:2005
IP classification
EDDYTHERM 1x and EDDYTHERM 1-6 have the protection class IP22 (protected against penetration by objects with
a diameter greater than 12.5 mm, protection against dripping water).
EDDYTHERM 4x has the protection class IP20 (protected against penetration by objects with a diameter greater than
12.5 mm, no protection against water).
Safety precautions
Erecting the heater
Only erect the device on a level, firm and suitable surface.
The minimum load carrying capacity of the surface must be ensured.
Do not move the device while it is loaded.
Only operate the device if the mounting columns and crossbars are undamaged.
The mounting columns and crossbar must be clean, free of corrosion and level.
The maximum weight of the workpiece must be defined.
Comply with the material type and processing temperature specifications for the workpiece.
Do not store flammable materials in the vicinity of the device.
Only operate the device with the voltage and current type specified on the type label. Only connect the
device to a properly installed power supply. An overvoltage protection device must be integrated in the
power supply.
Protect the heater against moisture.
The device and the various controls should be easily accessible.
1
These general instructions provide information and tips on operating the EDDYTHERM.
Numbers in red circles indicate the operating steps described in these instructions.
They must be performed in the order indicated.
This symbol indicates the connector for the temperature probe.
